Centering the model

[danglass]

How can I get 3D_PDF to center the model correctly?

The 3D PDF model can be:

way off to one side
zoomed in too close and 30% of the model is outside of the viewer
or just not dead center


All of the Sketchup models I tested have the camera set especially so that the view is just right, but this is not preserved on conversion.

[Al]

Send is a model with three page views and as little geometry as possible and we will take a look at it.

Make sure you have "Use SketchUp view pages" checked.

[danglass]

This one is zoomed in to close:
LUMIVENT AUTOMATIC FIRE VENT - TRANSLUCENT COVER (http://www.concept3d.com/models/download.php?ModelName=LUMIVENT+AUTOMATIC+FIRE+VEN T+-+TRANSLUCENT+COVER&Section=BPMs&FileName=AUTOMATIC%20FIRE%20VENT%20-%20TRANSLUCENT%20COVER%20-%20%20%20LUMIVENT)

This one is off to the side:
Smoke Vent SVA4884D (http://www.concept3d.com/models/download.php?ModelName=Smoke+Vent+SVA4884D&Section=BPMs&FileName=SmokeVentSVA4884D)

Thanks,
Dan